Hornady Lock-N-Load Case Feeder Manual do Utilizador descarregar pdf (Página 8)

Installing the V-Block onto the

case slide.

With the Ram at the bottom of the stroke (idle position), set the

V-Block onto the Case Slide (38).

Refer to chart on page 13 for proper V-Block.

Place the #10-24 X 1/2 Cap Screw (59) through the hole of the

V-Block and screw it into the Case Slide. Before you tighten the

Cap Screw, push the V-Block back into the Case Slide and snug

the Cap Screw with your ﬁngers.

The proper adjustments of the cam wire will be discussed later

on Change-Over: Case Feeder Page 14.

Assembling the Feed Tube End

and Pivot.

If the maximum case diameter is larger than .43" you will

need to use the large Drop Tube (22). If it is smaller, you will

need the small Drop Tube (53). Place the correct one into the

Pivot Block (29).

Place the Torsion Spring (23) into the slot in the Pivot

Block (29), leaving the long leg on the top side. The Spring

will only ﬁt one way.

Torsion Spring

Drop Tube

Pivot Block

V-Block

Cap Screw

- 8 -

ASSEMBLY

ASSEMBLY: CASE FEEDER

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Sem comentários

Hornady Lock-N-Load Case Feeder Manual do Utilizador Página 8